1 Installing the PXI Chassis Hardware
Keysight M9347AH02 Getting Started Guide 3
Set Up the PXI Chassis
1. Using the PXI Chassis’ Installation and Quick Start Guide
(https://literature.cdn.keysight.com/litweb/pdf/M9019-90001.pdf?id=2766869),
set up the PXI Chassis. Do not power on the chassis.
2. Insert the PXI modular instrument cards and controller into the appropriate slots
according to the instillation manual.
3. Make sure all cards are securely locked in place.
4. Power on the PXI chassis.
Do not remove or insert any PXI cards into the chassis with the
power on. This could cause irreparable damage to both the cards
and the chassis.
Ventilation Requirements: When installing the product in a
cabinet, the convection into and out of the product must not be
restricted. The ambient temperature (outside the cabinet) must
be less than the maximum operating temperature of the
instrument by 4
o
C for every 100 watts dissipated in the cabinet. If
the total power dissipated in the cabinet is greater than 800
watts, then forced convection must be used.
Consider this when selecting the location of your system.
Hookup Guide
Do not turn on the M9347A without a clock signal input. See
"Clock Selection" on page 8.
The ideal clock drive level is between 0 and -6 dBm.
Contacting Keysight
Assistance with test and measurements needs and information on finding a local
Keysight office are available on the Web at: http://www.keysight.com/find/assist
To Next Page
Loading...
Need help?
General