Installation Note N9020-90180 3
Option ERC - External Reference Coupling Installation Kit
Option ERC - External Reference Coupling Installation Kit
Introduction
This kit contains all of the instructions required to install Option ERC on an Keysight X-Series Signal
Analyzers. No tools are required.
Products Affected: CXA N9000A
EXA N9010A
MXA N9020A
PXA N9030A
Serial Numbers: All
To Be Performed By: (X) Keysight Service Center
(X) Personnel Qualified by Keysight
(X) Customer
Estimated Installation Time:
Estimated Adjustment and Verification Time:
0.5 Hours
0.5 Hours
1. The signal analyzer being upgraded with this option must have software
version A.02.00 or newer. To verify that the current version meets this
requirement, press System, Show, System and look for the “Instrument S/W
Revision”.
The latest revision of the X-Series Signal Analyzers software may be
downloaded from
http://www.keysight.com/find/xseries_software.
If a software update is required, you MUST follow the procedure in this
document for redeeming and installing of the option upgrade license key,
BEFORE attempting the software update.
2.
This option is licensed for one instrument model/serial number
combination. The license key will only install on the designated
instrument.
To Next Page
Loading...
