Need help?Do you have a question about the Keysight Infiniium DSOS104A and is the answer not in the manual?
General| Bandwidth | 1 GHz |
|---|---|
| Channels | 4 |
| Vertical Sensitivity | 1 mV/div to 10 V/div |
| Vertical Resolution | 8 bits |
| Input Coupling | AC, DC, GND |
| Display | 12.1-inch capacitive touchscreen |
| Input Impedance | 1 MΩ |
| Operating System | Windows 10 |
| Connectivity | USB, LAN, HDMI |
| Weight | 4.5 kg |
Verify received items, check for damage, and contact sales office for missing parts.
Connect mouse, keyboard to USB ports and LAN cable to the RJ-45 connector for network access.
Guidance on connecting the power cord to the unit and a suitable AC voltage source.
Steps to attach probe connectors to channels or trigger input and connect to the circuit of interest.
Press the power switch located in the lower left corner of the oscilloscope's front panel.
Confirm operation by connecting a probe, using Default Setup/Auto Scale, and testing the touch screen.
Explains UI elements around the waveform display, context-sensitive menus, and interaction areas.
Control acquisition process using Run/Stop/Single buttons and set sampling rate and mode.
Split display into main and zoomed timebase windows to magnify specific waveform sections.
Configure trigger conditions: edge, source, slope, level, and other parameters for signal acquisition.
Step-by-step guide for edge triggering using Source, Slope, and Level controls.
Use measurement controls for markers, quick actions, and performing automatic measurements.
Follow steps to perform default setup or factory reset for normal oscilloscope operation.
To Next Page
