Need help?Do you have a question about the Keysight Infiniium DSOS204A and is the answer not in the manual?
General| Bandwidth | 200 MHz |
|---|---|
| Channels | 4 |
| Vertical Resolution | 8 bits |
| Input Coupling | AC, DC, GND |
| Operating Temperature | 0 °C to 50 °C |
| Input Impedance | 50 Ω or 1 MΩ |
| Connectivity | USB, LAN |
| Weight | 4.5 kg (9.9 lbs) |
Verify that you received the correct items in the Infiniium oscilloscope packaging.
Connect mouse, keyboard, and LAN cable to the appropriate ports on the oscilloscope.
Connect the power cord to the oscilloscope and a suitable AC voltage source.
Attach probe connector to channel, connect probe to circuit, and disconnect probe.
Press the power switch on the front panel to turn on the oscilloscope.
Connect probe, apply default setup, auto scale, and test touch screen.
Press the power switch to turn off the oscilloscope.
Describes channel inputs, digital channels connector, probe compensation terminal, and ground plug.
Details motherboard I/O, clock sync, and BNC connectors on the right side panel.
Describes front panel controls for direct access to measurements and settings.
Controls for running, stopping, and making single waveform acquisitions.
Configure trigger conditions (source, slope, level, mode) to acquire signals.
Configure source, slope, and level for edge triggering.
Use measurement controls to display markers, define keys, and make measurements.
Drag measurement icons or use dialog box to specify source and type of measurement.
To Next Page
