Keysight M8195A – Arbitrary Waveform Generator
Getting Started Guide
2 M8195A Software
Installation
2.1 Pre-Requisites / 13
2.2 Installation Process / 14
2.3 Post Installation Steps / 22
2.4 How to use the Instrument / 23
This chapter explains the steps required to install M8195A software package.
2.1 Pre-Requisites
The following are the pre-requisites for installing Keysight M8195A software:
The supported operating systems are:
Windows 8.1 (32 bit or 64 bit)
Windows 8 (32 bit or 64 bit)
Windows 7 (32 bit or 64 bit)
Ensure that you have Keysight IO Libraries Suite Version 16.3 or higher
installed on your system. The Keysight IO Libraries Suite can be found on
the CD that is part of shipment content or at
http://www.keysight.com/find/iosuite.
Even if a non-Keysight I/O library is already installed on your PC, it is still necessary
to install the Keysight I/O library. The Keysight I/O library will install as “secondary”
I/O library in this case. This use case is fully supported. There only needs to be some
additional considerations when doing SCPI remote programming. For more
information on SCPI remote programming, refer to M8195A User's Guide.
To Next Page
Loading...
