Keysight MXA Series User Manual

Installation Note N9020-90185 7
Option CR3 or CRP Installation Kit
Functional Check:
Within one year of the initial calibration date of the instrument this option is fully calibrated with no
further adjustment or verification testing. To ensure that this newly installed option has been
enabled correctly the following functional check is recommended.
1. Press System, Show, Errors, Clear Error Queue. This will remove out-of-date errors.
2. Press System, Alignments, Align Now, All.
3. Watch for any errors during the instrument alignment.
4. Press System, Show, Errors to view the instrument error log.
5. Verify that there were no errors during the alignment.

Keysight MXA Series Specifications

General

Resolution Bandwidth (RBW)	1 Hz to 10 MHz
Video Bandwidth (VBW)	1 Hz to 10 MHz
Display	10.4-inch touchscreen
DANL	-166 dBm at 1 GHz (typical, with preamp on)
Connectivity	LAN, USB, GPIB
Amplitude Range	+30 dBm
Dimensions	177 mm (H) x 426 mm (W)
Phase Noise	-98 dBc/Hz at 10 kHz offset (1 GHz carrier)