Keysight MXA Series User Manual

Notice: This document contains references to Agilent.
Please note that Agilent’s Test and Measurement business
has become Keysight Technologies. For more information,
go to www.keysight.com.
Keysight MXA Signal Analyzer
Keysight EXA Signal Analyzer
Option CR3
Second IF Out or
Option CRP
Arbitrary IF Out
Installation Note

Keysight MXA Series Specifications

General

Resolution Bandwidth (RBW)	1 Hz to 10 MHz
Video Bandwidth (VBW)	1 Hz to 10 MHz
Display	10.4-inch touchscreen
DANL	-166 dBm at 1 GHz (typical, with preamp on)
Connectivity	LAN, USB, GPIB
Amplitude Range	+30 dBm
Dimensions	177 mm (H) x 426 mm (W)
Phase Noise	-98 dBc/Hz at 10 kHz offset (1 GHz carrier)

Summary

Option CR3 or CRP Installation Kit

Introduction

Explains the purpose of the kit, required hardware, and prerequisites for installation.

Contents and Required Tools

Lists the items in the kit and the tools needed for installation and verification.

Installation Procedure over USB

Provides step-by-step instructions for installing the option using a USB storage device.

Alternate Installation Procedure

Describes manual methods for installing the license file via USB or LAN.

Verify the Installation

Details the steps to confirm that the option has been successfully installed.

Functional Check

Recommends a functional check to ensure the newly installed option operates correctly.

Manual Verification Steps

Step-by-step guides to manually verify Option CR3 and Option CRP functionality.

Utilities, Adjustments, and Performance Verification

Information on calibration software, required adjustments, and performance testing.