Keysight MXA Series User Manual

Installation Note N9020-90185 9
Option CR3 or CRP Installation Kit
Utilities, Adjustments, and Performance Verification Tests
Calibration Software and specified test equipment is required to perform the adjustments, and can
be used to automate the performance verification testing. Information on how to obtain this
software can be found at
http://www.keysight.com/find/calibrationsoftware
Utilities Required
None
Adjustments Required
None
Performance Testing Required
None
A full calibration is required to assure the instrument meets all specifications
The end user must ultimately determine whether they want a full calibration to be performed after
the installation of this upgrade or not. If a full calibration is required, arrangements regarding the
level of calibration must be made between the end user and the calibration provider.
For assistance, contact your nearest Keysight Technologies Sales and Service Office. To find your
local Keysight office access the following URL, or if in the United States, call the following
telephone number:
http://www.keysight.com/find/assist
1-800-829-4444 (8 am - 8 pm ET, Monday - Friday)

Keysight MXA Series Specifications

General

Resolution Bandwidth (RBW)	1 Hz to 10 MHz
Video Bandwidth (VBW)	1 Hz to 10 MHz
Display	10.4-inch touchscreen
DANL	-166 dBm at 1 GHz (typical, with preamp on)
Connectivity	LAN, USB, GPIB
Amplitude Range	+30 dBm
Dimensions	177 mm (H) x 426 mm (W)
Phase Noise	-98 dBc/Hz at 10 kHz offset (1 GHz carrier)