3-2 Installation and Service Guide N5251-90001
System Installation
Receiving the System
PNA Series Microwave Network Analyzer System
N5251A
Receiving the System
The N5261A and N5262A millimeter head controllers and the test head
modules are sensitive to electrostatic discharge (ESD). Ground your work
station before unpacking and installing the test head modules. See
“Electrostatic Discharge Protection” on page 1-4.
The System as Shipped
The N5251A system components will arrive packaged separately. For a complete list of
components shipped with your system, refer to Table 3-1 on page 3-3 and Table 3-2 on page 3-4.
When the entire shipment has arrived, contact Keysight Technologies to arrange for system
installation. See “Keysight Support, Services, and Assistance” on page 5-4.
Keep the shipping containers until the system checklist has been completed, and the system has
been checked for physical damage.
If the shipping container is damaged or the packaging material shows signs of stress, notify the
carrier as well as Keysight Technologies. Keep the shipping materials for the carrier’s inspection.
Keysight Technologies will arrange for repair or replacement of damaged equipment without
waiting for a claim settlement from the carrier. Refer to “Keysight Support, Services, and
Assistance” on page 5-4.
Keysight Technologies Customer Engineering
A Keysight Technologies Customer Engineer will be assigned to help you install the system. During
installation, the Customer Engineer will do the following:
• Unpack the system components.
• Complete the system checklist, see Table 3-1 on page 3-3 and Table 3-2 on page 3-4.
• Connect the N5227A PNA and the N5261A or N5262A millimeter head
controller.
• Install the millimeter-wave test head modules.
• Run a performance verification of the system, which includes a measurement
calibration.
• Provide training for one user.
To Next Page
Loading...
