Keysight N5227A - Page 43

Installation and Service Guide N5251-90001 4-3
System Specifications
Specifications
4
0 GHz to 45 GHz
–
99
–
106
4
5 GHz to 50 GHz
–
97
–
104
5
0 GHz to 60 GHz
–
97
–
104
6
0 GHz to 67 GHz
–
92
–
103
6
7 GHz to 70 GHz
–77 –
84
7
0 GHz to 75 GHz
–81
–
87
7
5 GHz to 80 GHz
–91
–
97
80 GHz to 100 GHz –9
4
–
100
100 GHz to 110 GHz –9
5
–
100
System Dynamic Range (dB)
1.0 mm
Test Port
1.85 mm
PNA Port
Waveguide Port
10 MHz to 45 MHz +63 +65
45 MHz to 500 MHz +94 +97
500 MHz to 2 G
Hz
+120 +1
23
2 GHz to 10 GHz +116 +123
10 GHz to 24 GHz +1
11
+121
24 GHz to 30 GHz +1
00
+112
30 GHz to 40 GHz +92 +107
40 GHz to 45 GHz +84 +101
45 GHz to 50 GHz +85 +103
50 GHz to 60 GHz +80 +100
60 GHz to 67 GHz +7
5
+95
6
7 GHz to 70 GHz
+68
+82
7
0 GHz to 75 GHz
+74 +
87
7
5 GHz to 80 GHz
+85
+
98
80 GHz to 100 GHz +8
9
+101
100 GHz to 110 GHz +87
+98
Test Port Damage Level (dBm)
1.0 mm
Test Port
1.85 mm
PNA Port
Waveguide Port
10 MHz to 110 GHz +27 +27 +27
a. Assumes a 30 inch cable from the PNA 1.85 mm Test Port Out is used to provide the 10 MHz to
67 GHz source signal. The standard configuration does not have a bias-tee in the 1.0 mm test head
and uses this connection.
b. Assumes a 30 inch cable from the PNA Source Out bulkhead connector is used to provide the 10
MHz to 67 GHz source signal. The Option 017 and 018 configurations includes a bias-tee in the 1.0
mm test head and use this connection.
PNA Series Microwave Network Analyzer System N5251A
Table 4-1 Typical System Specifications (Continued)