Keysight N5741A - Connecting the Load

Installation 2
Series N5700 User’s Guide 23
Connecting the Load
WARNING
SHOCK HAZARD Turn off AC power before making rear panel connections.
All wires and straps must be properly connected with screws securely
tightened.
As further explained in this section, the following factors should be
considered when selecting wiring to connect the load to the power
supply:
• Current carrying capacity of the wire
• Insulation rating of the wire should be at least equivalent to
the maximum output voltage of the power supply
• Maximum wire length and voltage drop
• Noise and impedance effects of the load wiring
Wire Size
WARNING
FIRE HAZARD
To satisfy safety requirements, select a wire size heavy enough
not to overheat while carrying the power supply load current at the rated
load, or the current that would flow in the event the load wires were shorted,
whichever is greater.
Along with conductor temperature, you must also consider voltage
drop when selecting wire sizes. The following chart lists the
resistance for various wire sizes and also the maximum lengths to
limit the voltage drop to 1.0 volt for various currents.
Although the power supply will compensate for up to 5V in each load
wire, it is recommended to minimize the voltage drop to less than 1V
to prevent excessive output power consumption from the power
supply and poor dynamic response to load changes.
Wire size
AWG
Resistance
Ω
/1000 foot
Maximum length in feet to limit voltage to 1 V
for 5 A for 10 A for 20A for 50A for 150A
14
2.526
80
40
20
8
2
12
1.589
120
60
30
12
3.4
10
0.9994
200
100
50
20
6
8
0.6285
320
160
80
32
10
6
0.3953
500
250
125
50
16
4
0.2486
800
400
200
80
26
2
0.1564
1200
600
300
125
40
0
0.0983
2000
1000
500
200
68