Installation Note N9048-90017 15
Option EXM, External Mixing Upgrade Kit
6. Locate semi-rigid coax cable, part number N9020-20132 in the upgrade kit. This is W17.
Connect the end with the SMA male connector A13A1J8, with the SMA female connector
pointing towards where the front panel would be. The long, straight section of W17 should be
parallel to the casting of the A13 Front End and parallel to the side chassis. Refer to Figure 11.
Torque the cable nut to 10 inch-pounds.
Figure 11 Orientation of W17 in an RF/Microwave PXEA
To Next Page
Loading...
