Installation Note N9048-90017 25
Option EXM, External Mixing Upgrade Kit
Top Brace Replacement
1. Refer to Figure 24 and Figure 23. To replace the top brace, place the brace and the wire
holddown in the correct position. Using the twelve screws (3) (0515-0372), attach the top
brace and wire holddown to the chassis. Attach the top brace to the boards using the fourteen
screws (or sixteen with Option WF1) (4) (0515-1946) included in the kit.
2. Torque all screws to 9 inch-pounds.
Figure 23 Wire Holddown
To Next Page
Loading...
