16 Installation Note N9048-90017
Option EXM, External Mixing Upgrade Kit
Add Cables to A13 Front End and A15 Front End Controller, Millimeter Wave
Instruments
1. Locate the flexible coax cable in the Opt EXM Cable Kit. This is cable W30 and should be
labeled "8121-2027".
2. Refer to Figure 12. Connect the end of W30 labeled “903” to A15J903.
Figure 12 A15J903
This procedure only applies to Millimeter Wave instruments (frequency range options 544 and
550). If your instrument has frequency range option 503, 508, or 526, refer to “Add Cables to
A13 Front End and A15 Front End Controller, RF/Microwave Instruments” above.
To Next Page
Loading...
