1 Introduction
Preparing Your Multimeter
12 U1231A/U1232A/U1233A User’s Guide
Ensure that the Keysight logo on the U1173A IR- USB cable
(purchased separately) connected to the multimeter is facing
up. Firmly push the IR head into the multimeter’s IR
communication port until it snaps into place (see
Figure 1- 3).
Refer to the Keysight GUI Data Logger Software Help and
Quick Start Guide for more information on the IR
communication link and the Keysight GUI Data Logger
software.
Figure 1-4 Keysight GUI Data Logger Software
The Keysight GUI Data Logger software and its supporting
documents (Help and Quick Start Guide) are available as free
downloads from http://www.keysight.com/find/hhTechLib.
You may purchase a U1173A IR- USB cable from a Keysight
Sales Office nearest to you.
Communication settings for U1231A/U1232A/U1233A
The baud rate, data bits, and parity bit are fixed respectively to 9600 bps,
8-bit, and none for the U1231A/U1232A/U1233A handheld digital
multimeter. Ensure that the communication settings on the Keysight GUI
Data Logger match the communication settings mentioned in this note.
To Next Page
Loading...
