3Setup Options
84 Keysight U1731C/U1732C/U1733C User’s Guide
Changing the data bits
This setting is used with the IR communication link and the Keysight GUI Data
Logger software to control your LCR meter remotely (page 25).
Use this Setup item to change the number of data bits (data width) for remote
communications with a PC. The number of the stop bit is always 1, and this
cannot be changed.
Figure 3-12 Changing the data bits
Parameter Range Default setting
dAt 7-bit or 8-bit 8-bit
To Next Page
Loading...
