Keystone KSTAP08MFC - OPERATION; Pre-Operation and Location Setup; Operating Modes and Auto-Restart

OPERATION
Observe all governing codes and ordinances.
Check the location where the air conditioner will be installed. Make sure you have everything
necessary for correct installation.
The location should provide:
1. Ground electrical outlet located near the product. The power cord length is 4.3' (131cm).
2. Free movement of air in room to be cooled.
3. A large enough opening for the air conditioner, installation parts are supplied for
double-hung windows.
4. Allow at least 23.6" (60cm) clearance from walls and furniture.
Failure to follow the below precaution could result in electrical shock, fire, or
personal injury.
1. Plug into a ground 3 prong outlet.
2. Do not remove ground prong
3. Do not use an extension cord
4. Do not user an adapter.
⚠ WARNING
Before starting the unit
1. Press the MODE button in a sequence until the heat indicator is lighted.
2. Press the “+” and “-” buttons to set your desired temperature.
3. Press the FAN button to select the fan speed.
Heating operation mode (Cooling only model has no heating function)
1. Press the MODE button in a sequence until the cool indicator is lighted.
2. Press the “+” and “-” buttons to set your desired temperature.
3. Press the FAN button to select the fan speed.
Cooling operation mode
1. Press the MODE button in a sequence until the dry indicator is lighted.
2. The fan will run at a fixed speed at this operation mode.
3. Close any windows and doors for the best dehumidifying effect.
Note: The setting temperature and fan speed can not be adjusted. The setting
temperature is 25º (77º F) and the fan speed is low.
Note: Cabinet louvers mush not be obstructed. Do not place the unit in front of
drapes or curtains; they may block the air intake.
Note: The setting temperature can not be adjusted.
Drying operation mode
1. Press the MODE button in a sequence until the fan indicator is lighted.
2. Press the FAN button to select the fan speed.
Fan operation mode
If power to the unit is interrupted, the unit will restart itself in its last used mode/ settings once
power is restored. The compressor will restart after 4 minutes.
1. To set the “Auto-restart function”: Press the sleep button 10 times within 5 seconds, a
buzzer will sound 4 times.
2. To cancel the “Auto-restart function”: Press the sleep button 10 times within 5 seconds, a
buzzer will sound 2 times.
Auto-restart function:
- 10 -