KHE ACS SERIES – USER MANUAL www.KHE-AudioElectronics.com 3 / 23
Congratulations on your purchase of a KHE Amplifier Cabinet Selector !
The KHE ACS is a switching and routing system for guitar amplifiers, speaker cabinets and load boxes.
Connect them to the ACS, power them up, and you are ready to go : Switch and play between all
your amps, speakers and loadboxes by a single push of a button. Use stompboxes like boosts and
overdrives with all amplifiers, and share effect pedals like delays or gates in the fx-loops of all
amplifiers. No need to interrupt or stop playing - switch all amps and cabs on the fly !
The KHE ACS-Series is the ultimate solution for any situation where more than one amp or cab is
available : recording studios, reampers & profilers, gear enthusiasts & collectors, music stores &
showrooms, amp manufacturers, repair shops, gear reviews & comparisons and live musicians.
The KHE ACS-Series features an extensive product line-up with a total of 7 different switchers,
providing the perfect switching configuration for any kind of setup or application. All switchers can
be dasy-chained and linked together to create the most flexible switching system possible. This
manual covers all 7 switchers and their use, functions and features.
To take advantages of all the features that have been implemented into the ACS, please take your
time to read through this manual before you use the switcher. If you have any questions that are not
answered in this manual, please refer to the FAQ section on our website. If you have any questions
or feedback, please contact us at info@khe-audioelectronics.com .
RULES OF OPERATION
NEVER change cable wiring while ACS, amps or load boxes are powerd ON.
NEVER unplug any connections of an amplifier that is connected to the ACS while the amplifier is on.
NEVER unplug the amplifier input cable and never plug the guitar cable straight in the amp input.
NEVER exceed the maximum amplifier & load power rating.
NEVER unplug a power attenuator in the power attenuator insert while the ACS is ON.
ALWAYS power-on the ACS before the connected equipment.
BE CAREFUL when using built-in time-based effects in amps like reverb or delay. Always make sure to either
A) turn the effect pedal off before disableing or changing an amp or
B) let the effect completely ring out before disabeling / changing the amp.
These rules also apply to permanentely connected effect pedals in the fx-loop of a single amplifier.
Ignoring these rules can damage the ACS or the connected equipment.
INTRODUCTION
To Next Page
Loading...
Need help?
General
