Fig. 143: Exploded View Of Water Pump Assembly
Courtesy of KIA MOTORS AMERICA, INC.
INSTALLATION
1. Clean the gasket mating surface of the water pump body and cylinder block.
2. After installing new O-ring in the groove at front of the water pipe, soak it with water. At this time, do
not soak it with oil or grease.
3. After installing a new water pump gasket and water pump assembly, tighten it to the specified torque, see
Fig. 144 .
Tightening torque:
(A) 5EA:14.7-21.6 N.m (150-220 kg.cm, 10.8-15.9 lb.ft)
(B) 1EA:32.4-49.0 N.m (330-500 kg.cm, 23.9-36.2 lb.ft)
(C) 2EA:19.6-26.5 N.m (200-270 k
.cm, 14.5-19.5 lb.ft)
2002 Kia Sedona EX
2002 ENGINES 3.5L V6 - Sedona
Helpmelearn
June-06-08 8:54:32 AM Page 145 © 2005 Mitchell Repair Information Company, LLC.
To Next Page
Loading...