Fig. 83: Insert Wall Removal Diagram
Courtesy of KIA MOTORS AMERICA, INC.
2. After removing the seat insert, match the seat insert bore using a reamer or cutter to the indicated size in
the table below.
3. Heat the cylinder head up to 250°C and press in an oversize seat insert. At this time, the temperature of
oversize seat insert must be the same as the room temperature. When new valve seat is installed, adjust
the valve seat face. For valve seat specifications, see chart in figure 84.
Fig. 84: Valve Seat Specifications Chart
Courtesy of KIA MOTORS AMERICA, INC.
VALVE GUIDE REPLACEMENT PROCEDURE
2002 Kia Sedona EX
2002 ENGINES 3.5L V6 - Sedona
Helpmelearn
June-06-08 8:54:30 AM Page 83 © 2005 Mitchell Repair Information Company, LLC.
To Next Page
Loading...