Features of your vehicle
1264
Turn signals and lane change sig-
nals
The ignition switch must be on for the
turn signals to function. To turn on the
turn signals, move the lever up or down
(A). Green arrow indicators on the instru-
ment panel indicate which turn signal is
operating.
They will self-cancel after a turn is com-
pleted. If the indicator continues to flash
after a turn, manually return the lever to
the OFF position.
To signal a lane change, move the turn
signal lever slightly and hold it in position
(B). The lever will return to the OFF posi-
tion when released.
OED040804
WARNING
• Do not place any accessories,
stickers or tint the windshield.
• Have the windshield glass
replaced from an authorized deal-
er.
• Do not remove or impact related
parts of the high beam assist.
• Be careful that water doesn’t get
into the high beam assist unit.
• Do not place objects on the dash-
board that reflects light such as
mirrors, white paper, etc. The sys-
tem may malfunction if the sun-
light is reflected.
• At times, the high beam assist
system may not work properly,
always check the road conditions
for your safety. When the system
does not operate normally, manu-
ally change the high beam and
low beam.
CAUTION
• When the headlamp is not
repaired or replaced at an author-
ized dealer.
• When the headlamp aiming is not
properly adjusted.
• When driving on a narrow curved
road or rough road.
• When driving downhill or uphill.
• When part of the vehicle in front
is visible.
• When there is a traffic light,
reflecting sign, flash sign or mir-
ror.
• When the road conditions are bad
such as being wet or covered
with snow.
• When the front vehicle’s head-
lights are off but the fog lights on.
• When a suddenly appears from a
curve.
• When the vehicle is tilted from a
flat tire or being towed.
To Next Page
Loading...
