Turn signals and lane change
signals
The ignition switch must be on for the
turn signals to function. To turn on the
turn signals, move the lever up or down
(A). The green arrow indicators on the
instrument panel indicate which turn
signal is operating. They will self-cancel
after a turn is completed. If the indica‐
tor continues to flash after a turn,
manually return the lever to the OFF
position.
To signal a lane change, move the turn
signal lever slightly and hold it in posi‐
tion (B). The lever will return to the OFF
position when released.
If an indicator stays on and does not
flash or if it flashes abnormally, one of
the turn signal bulbs may be burned
out and will require replacement.
One-touch lane change function (if
equipped)
To activate an one-touch lane change
function, move the turn signal lever
slightly and then release it. The lane
change signals will blink 3, 5 or 7 times.
You can choose one-touch lane change
blinking function in One touch turn
lamp of User settings. Refer to User
settings on page 4-72.
NOTICE
If an indicator flash is abnormally
quick or slow, a bulb may be burned
out or have a poor electrical connec‐
tion in the circuit.
Front fog light (if equipped)
Fog lights are used to provide improved
visibility when visibility is poor due to
fog, rain or snow, etc. The fog lights
will turn on when the fog light switch
(1) is turned on after the parklight is
turned on.
To turn off the fog lights, turn the fog
light switch (1) to the OFF position.
Features of your vehicle
4-100
To Next Page
Loading...
Need help?
General
