Lumbar support (for driver’s seat,
if equipped)
The lumbar support can be adjusted by
pressing the lumbar support switch on
the side of the seat. Press the front
portion of the switch to increase sup‐
port, or the rear portion of the switch,
to decrease support. Release the
switch once it reaches the desired posi‐
tion.
Driver position memory system
(if equipped, for power seat)
A driver position memory system is
provided to store and recall the driver
seat position with a simple button op‐
eration. By saving the desired position
into the system memory, different
drivers can reposition the driver seat
based upon their driving preference. If
the battery is disconnected, the posi‐
tion memory will be erased and the
driving position should be restored in
the system.
WARNING
Never attempt to operate the driver
position memory system while the
vehicle is moving.
This could result in loss of control,
and an accident causing death, seri‐
ous injury, or property damage.
Storing positions into memory
using the buttons on the door
Storing driver's seat positions
1. Vehicle speed is below 3 km/h and
the engine start/stop button is ON
or ignition switch ON.
2. Adjust the drivers seat comforta‐
ble for the driver.
3. Press SET button on the control
panel. The system will beep once.
4. Press one of the memory buttons
(1 or 2) within 5 seconds after
pressing the SET button. The sys‐
tem will beep twice when memory
has been successfully stored.
Recalling positions from memory
1. Vehicle speed is below 3 km/h.
Safety features of your vehicle
3-08
To Next Page
Loading...
Need help?
General
