EasyManua.ls Logo

Kia Cerato - Hazard Warning Flasher; Rearview Camera

Kia Cerato
655 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4105
Features of your vehicle
REARVIEW CAMERA (IF EQUIPPED)
The rearview camera will activate
when the back-up light is ON with the
ignition switch ON and the shift lever
in the R (Reverse) position.
NOTICE
The warning "Warning ! Check sur-
roundings for safety " will appear
on the rearview display when the
rearview camera is activated.
The hazard warning flasher should be
used whenever you find it necessary
to stop the vehicle in a hazardous
location. When you must make such
an emergency stop, always pull off
the road as far as possible.
The hazard warning lights are turned
on by pushing in the hazard switch.
Both turn signal lights will blink. The
hazard warning lights will operate
even though the key is not in the igni-
tion switch.
To turn the hazard warning lights off,
push the switch again.
WARNING
This system is a supplemen-
tary function only. It is the
responsibility of the driver to
always check the inside/out-
side rearview mirror and the
area behind the vehicle before
and whilst backing up because
there is a dead zone that can't
be seen by the camera.
Always keep the camera lens
clean. If lens is covered with
foreign matter, the camera
may not operate normally.
OYD046015L
HAZARD WARNING
FLASHER
OYDEEM2001R

Table of Contents