59
Driving your vehicle
Starting and stopping the engine
for turbocharger intercooler
1. Do not race or accelerate the
engine immediately after starting.
If the engine is cold, idle for sever-
al seconds before sufficient lubri-
cation is ensured in the tur-
bocharger unit.
2. After high speed or extended driv-
ing, requiring a heavy engine load,
idle the engine about 1 minute
before turning it off.
This idle time will allow the tur-
bocharger to cool prior to shutting
the engine off.
Stopping the petrol engine/
diesel engine
(Manual Transaxle)
1. Make sure the vehicle is complete-
ly stopped and keep the clutch
pedal and brake pedal depressed.
2. Shift the transaxle into Neutral
while depressing the clutch pedal
and brake pedal.
3. Engage the parking brake while
depressing the brake pedal.
4. Turn the ignition key to the LOCK
position and remove it.
CAUTION
If the engine stalls whilst you are
in motion, do not attempt to
move the shift lever to the P
(Park) position. If traffic and road
conditions permit, you may put
the shift lever in the N (Neutral)
position whilst the vehicle is still
moving and turn the ignition
switch to the START position in
an attempt to restart the engine.
CAUTION
• Do not engage the starter for
more than 10 seconds. If the
engine stalls or fails to start,
wait 5 to 10 seconds before re-
engaging the starter. Improper
use of the starter may damage
it.
• Do not turn the ignition switch
to the START position with the
engine running. It may dam-
age the starter.
CAUTION
Do not turn the engine off imme-
diately after it has been subject-
ed to a heavy load. Doing so
may cause severe damage to
the engine or turbocharger unit.
To Next Page
Loading...
Need help?
General
