Vehicle safety controls
OMV043100L
3rd row seats
1 Rear right seat belt fastening buckle
2 Rear left seat belt fastening buckle
Adjusting the height of the shoulder belt
Operation
• Pull the height adjuster up (1). Press the height adjuster button (2) and push the
height adjuster down (3).
TIP
There will be an audible "click" when the tab locks into the buckle.
WARNING
• You should place the lap belt portion as low as possible and snugly across your
hips, not on your waist. If the lap belt is located too high on your waist, it may in
crease the chance of injury in the event of a collision. Both arms should not be un
der or over the belt. Rather, one should be over and the other under, as shown in
the illustration. Never wear the seat belt under the arm near the door.
• Prior to fastening the rear seat belts, ensure the latch matches the seat belt buck
le. Forcefully fastening the left or right seat belt to the centre buckle can result in an
improper fastening scenario that will not protect you in an accident.
• After a collision, the seat belt system should be inspected to ensure it is operating
normally. Replace any belts that are not functioning appropriately.
• Verify the shoulder belt anchor is locked into position at the appropriate height.
Never position the shoulder belt across your neck or face.
CAUTION
• Do NOT fold down the left portion of the rear seatback when the rear centre seat
belt is buckled. ALWAYS UNBUCKLE the rear centre seat belt before folding down
the left portion of the rear seatback. If the rear centre seat belt is buckled when the
left portion of the rear seatback is folded down, distortion and damage to the top
portion of the seatback and seat belt garnish may result, causing the seatback to
lock into the folded down position.
152
To Next Page
Loading...
