3. DISABLE DIRECT HAZARDS / SAFETY REGULATIONS
Disabling vehicle
The final step in the initial response
process, conducted after immobilizing the
vehicle, is to disable the vehicle, its SRS
components and the high-voltage electrical
system. To prevent current flow through
the system, use one of the following
procedures to disable the vehicle.
Case 1:
1. EV off
2. 12 V battery disconnection
3. high-voltage shut off
Case 2*:
1. Fuse removal (Fuse box)
2. 12 V battery disconnection
3. high-voltage shut off
*In case of emergency
SRS : Supplemental Restraint System
3.1 Disabling the System – Smart
Key System and “EV”
START/STOP Button
1. Confirm the status of the READY light
on the instrument panel. If the READY
light is illuminated, the vehicle is ON.
a) If the READY light is NOT illuminated,
the vehicle is off. Do not push the “EV”
START/STOP button because the vehicle
may start (go into READY mode).
b) To turn OFF the system, press the 'P'
(Park) button on the rotary shifter dial, and
press the EV button.
2. If necessary, lower the windows,
unlock the doors and open the trunk as
required, before disconnecting the 12 V
battery. Once the 12 V battery is
disconnected, power controls will not
operate.
3. Before disconnecting the 12 V
battery, remove the smart key at least 2
meters (7 feet) away from the vehicle to
prevent accidental restart.
4. Open the hood after pressing the
release button twice.
Kia EV9
Emergency Response Guide
7
To Next Page
Loading...
