ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS. *IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
19
• To change the Cruise Control mode from SCC to standard Cruise
Control, press and hold button
A
(previous page). Repeat to switch
modes again (The SCC system must not be activated to change modes).
• For SCC to operate:
– When no vehicle is in front, you must be traveling at a minimum
speed of 20 mph
– When following a vehicle, you must be traveling at a minimum speed
of 6 mph
• When following a vehicle, the system can automatically adjust your
cruise speed based on the vehicle detected in front.
QUICK TIPS
REMINDERS:
• If SCC is left on, it can be activated inadvertently. Keep the system off when not in
use to avoid setting a speed which the driver is not aware of
• SCC is also canceled when the driver’s door is opened, gear shift is changed out of
D (Drive), and various other conditions. See owner’s manual for other conditions
• Keep the system off when not in use to avoid setting a speed which the driver is not
aware of
• Cruise Control button must be ON in order to turn SCC ON/OFF
– SCC is operating when driving above the speed of 6.0 mph
– SCC is activated when ignition is turned on. Speed will need to be reset when
ignition is cycled on
– SCC remains ON when ignition is cycled. The speed setting will need to be reset
when ignition is cycled
• In standard Cruise Control, the driver needs to manually assess the distance from
other vehicles as the system will not apply brakes to slow down automatically
• If your vehicle speed is between 5~20 mph when you press the Driving Assist
CRUISE button, the Smart Cruise Control speed will be set to 20 mph
Refer to section 5 in the Owner’s Manual for more information.
Smart Cruise Control (SCC)*
†6,22
(continued)
A
Driving Assist CRUISE button: Press to turn the Cruise Control ON/OFF
B
RES
+
button: Press up to resume, set speed or increase Cruising Speed
SET- button: Press down to set or decrease Cruising Speed
C
CANCEL button: To cancel Cruise Control, do one of the following:
• Press the brake pedal
• Press the CANCEL button
D
Switch modes: To switch between standard Cruise Control and Smart
Cruise Control, press and hold for more than two seconds
• Cruise Control is designed to function above 19 mph
• Cruise Control will not activate until the brake pedal has been depressed at
least once after ignition ON or engine start
QUICK TIPS
REMINDER: Standard Cruise Control is a part of Smart Cruise Control (SCC) and can be set as
the operating mode. To switch from SCC to standard Cruise Control, press and hold the SCC
button (SCC must not be activated to change modes). Repeat to switch back to SCC mode.
Cruise Control (CC)
†22
CRUISE
CANCELOK
RES
SET
—
+
—
+
MODE
CRUISE
CANCEL
RES
OK
SET
—
+
A
B
CD
STEERING WHEEL
CONTROLS
STEERING WHEEL CONTROLS
To Next Page
Loading...
