Features of your vehicle
324
Windows
If the power window does not operate
normally, the automatic power window
system must be reset as follows:
1. Place the ENGINE START/STOP but
-
ton to the ON position.
2. Close the window and continue pull
-
ing up the power window witch for at
least 1 second after the window is
completely closed.
Automatic reversal (For Type B)
If the upward movement of the window
is blocked by an object or part of the
body, the window will detect the resis
-
tance and will stop upward movement.
The window will then lower approxi
-
mately 30 cm (11.8 in) to allow the object
to be cleared.
If the window detects the resistance
-
whilst the power window switch ispulled
up continuously, the windowwill stop
upward movement then lower approxi
-
mately 2.5 cm (1 in).
And if the power window switch is pulled
up continuously again within 5 seconds
after the window is lowered by the auto
-
matic window reversal feature, the auto
-
matic window reversal will not operate.
The automatic reverse feature for the
window is only active when the “auto up”
feature is used by fully pulling up the
switch. The automatic reverse feature
will not operate if the window is raised
using the halfway position on the power
window switch.
Always check for obstructions before
raising any window to avoid injuries or
vehicle damage. If an object less than 4
mm (0.16 in) in diameter is caught
between the window glass and the
upper window channel, the automatic
reverse window may not detect the
resistance and will not stop and reverse
direction.
The automatic reverse feature doesn’t
active whilst resetting power window
system.
Make sure body parts or other objects
are safely out of the way before closing
the windows to avoid injuries or vehicle
damage.
To Next Page
Loading...
