Kicker 40ss - Troubleshooting

OPTIONAL MODULES
All KICKER amplifiers have a Module Docking Port, which allows the use of any
KICKER Module. These modules greatly Increase your amplifier's versatility, and
cost very little when compared to "stand alone' units with the same functions.
When not using a KICKER Module, the Bypass Module supplied with your amp
must be left in place.
Active Crossover Modules:
These 2-way modules allow you to use
separate amplifiers for your subwoofers, midbass
drivers, midranges, or tweeters. By doing this,
especially on the subwoofer, a clean and
undlstorted sound is available at much higher
listening levels.
Each module offers a range of selectable
crossover frequencies and 24dB/octave filtering.
• ASW - 60Hz, 80Hz, or lOOHz subwoofer/mIdbass or midrange crossover.
• AMR - 175Hz, 250Hz, or 350l-lz midbass/mIdrange crossover.
• ATW - 3500Hz or 4500Hz midrange/tweeter crossover.
Specialty Modules::
• AEE (Active Electronic Enclosure) - When used with KICKER Freealr^'^
woofers, this module simulates the response of KICKER Competition ™ woofers In a
sealed enclosure.
• AEQ (Active EQ) - Frequency Enhancement and extension module that
specializes frequencies in the low bass region as well as the upper treble regions.
• ACR (Active Center/Rear Fill) - This module allows one amplifier to drive a
center channel and rear speakers Independently at the same time.
• ARG (Active Remote Gain) - An Ideal amplifier enhancement module that
provides a remote gain control function.
Consult with your authorized KICKER dealer for more information.
TROUBLE SHOOTING
Power indicator off, no output.
With a Voit Ohm Meter (VOM),
• Check + 12V power terminal.
• Check GND terminal.
• Check remote turnon terminal.
Q Power indicator on, no output.
• Check RCA and speaker connections.
• Test speaker outputs with known good test speaker.
• With VOM In AC volts position, check RCA for Input voltage.
Q No output from one channei.
• Check RCA and speaker connections on that channel.
• Swap RCA connections between channels.
• Swap speaker connections between channels. 9