15English
2. Close the car windows, turn off the engine, turn
off the HVAC. Install the microphone to the top of the
driver’s side headrest. Make sure the microphone
faces up, pointing as straight as possible to the roof.
run mic wire
mic facing up
headrest
3. In most cases, the Bi-Amp switch should be OFF.
Check if you need to turn the Bi-Amp switch ON.
Refer to page 9 for more information
4. Start the Pink Noise. Set the Pink Noise volume to
a level above conversational (slightly loud) using your
audio source volume control (usually head-unit).
To Next Page
Loading...
