To Next PageTo Next Page
Need help?Do you have a question about the Kicker KXM800.5 and is the answer not in the manual?
Details RMS Power, Frequency Response, Signal-to-noise Ratio, Input Sensitivity, Crossover, Bass Boost, and Subsonic Filter.
Instructions on selecting a location and physically mounting the amplifier.
How to connect high-level and low-level signals and initial power/ground connection concepts.
Setting up the amplifier for four-channel output with a subwoofer.
Step-by-step guide to install the remote bass control knob.
How to select the automatic turn-on mode (+12V, DC Offset, Audio).
Adjusting input sensitivity, fader switch, and subwoofer input selection.
Setting input gain, KICK EQ bass boost, and internal crossover frequencies.
Interpreting the PRT LED and understanding protection modes like thermal or voltage.
Resolving problems like alternator noise, ground loops, and low output.
Steps to follow for returning defective merchandise for repair or replacement.
Specifies what is not covered by the limited warranty, such as improper installation or abuse.
Details RMS Power, Frequency Response, Signal-to-noise Ratio, Input Sensitivity, Crossover, Bass Boost, and Subsonic Filter.
Instructions on selecting a location and physically mounting the amplifier.
How to connect high-level and low-level signals and initial power/ground connection concepts.
Setting up the amplifier for four-channel output with a subwoofer.
Step-by-step guide to install the remote bass control knob.
How to select the automatic turn-on mode (+12V, DC Offset, Audio).
Adjusting input sensitivity, fader switch, and subwoofer input selection.
Setting input gain, KICK EQ bass boost, and internal crossover frequencies.
Interpreting the PRT LED and understanding protection modes like thermal or voltage.
Resolving problems like alternator noise, ground loops, and low output.
Steps to follow for returning defective merchandise for repair or replacement.
Specifies what is not covered by the limited warranty, such as improper installation or abuse.
General| Channels | 5 |
|---|---|
| Signal-to-Noise Ratio | > 95 dB |
| Bridged RMS Power at 4 Ohms | 200 Watts x 2 |
| Frequency Response | 20 Hz - 20 kHz |
| Bass Boost | 0-18dB |
