To Next PageTo Next Page
Need help?Do you have a question about the Kicker KXMA800.5 and is the answer not in the manual?
Important safety warnings regarding amplifier, speaker, and subwoofer operation, including overheating, fire risk, and proper ventilation requirements.
Details RMS power output for AMP1, AMP2, and SUB channels under various impedance and distortion conditions.
Explains the +12V, DC Offset, and Signal Sense (Audio) automatic turn-on modes for the amplifier.
Guides on setting input gain, Gain Matching, crossover switches, frequency multipliers, and subsonic filter.
Explains the use of specific test tone files for accurate gain matching to the amplifier's input.
Step-by-step guide to setting input gain and verifying it using the gain LED indicator to prevent clipping.
Details how to adjust Gain, SHOCwave, and Phase settings on the KXARC for the subwoofer channel.
Explains PRT LED indicators, thermal/voltage protection, and troubleshooting no/low output.
Important safety warnings regarding amplifier, speaker, and subwoofer operation, including overheating, fire risk, and proper ventilation requirements.
Details RMS power output for AMP1, AMP2, and SUB channels under various impedance and distortion conditions.
Explains the +12V, DC Offset, and Signal Sense (Audio) automatic turn-on modes for the amplifier.
Guides on setting input gain, Gain Matching, crossover switches, frequency multipliers, and subsonic filter.
Explains the use of specific test tone files for accurate gain matching to the amplifier's input.
Step-by-step guide to setting input gain and verifying it using the gain LED indicator to prevent clipping.
Details how to adjust Gain, SHOCwave, and Phase settings on the KXARC for the subwoofer channel.
Explains PRT LED indicators, thermal/voltage protection, and troubleshooting no/low output.
General| Channels | 5 |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| Input Sensitivity | 200mV - 4V |
| Signal-to-Noise Ratio | > 95dB |
| RMS Power at 4 Ohms | 100W x 4 + 400W x 1 |
| RMS Power at 2 Ohms | 100W x 4 + 400W x 1 @ 14.4V, 2Ω stereo ≤ 1% THD |
| Bridged RMS Power at 4 Ohms | 200W |
