Need help?Do you have a question about the Kicker KX200.2 and is the answer not in the manual?
General| Power Output (RMS) @ 2 Ohms | 100 watts x 2 |
|---|---|
| Bridged Power Output (RMS) @ 4 Ohms | 200 watts x 1 |
| Frequency Response | 10Hz - 20kHz |
| Signal-to-Noise Ratio | >95dB |
| Minimum Impedance Bridged | 4 Ohms |
| Minimum Impedance Unbridged | 2 Ohms |
| Input Voltage | 14.4V |
| Crossover Frequency Range | 50Hz-200Hz |
| Crossover Type | Variable Low-Pass |
Provides power output details @ specific impedances and THD.
Details the amplifier's frequency range capability.
Indicates audio clarity and noise level.
Defines the voltage levels for audio input.
Describes crossover filter settings for frequency management.
Details the variable bass boost control.
Instructions on physically attaching the amplifier securely.
Guidance on connecting power, ground, and signal wires.
Using the +12V remote lead from the source unit.
Detecting 6V DC offset from HI-Level speaker outputs.
Detecting incoming audio signal for turn-on.
Switching between Hi or Low-level input signals.
Matching source unit output to amplifier input.
Setting crossover frequencies for Hi-Pass, Lo-Pass, Band-Pass.
Adjusting bass boost from 0-18dB at 40Hz.
Interpreting red (PRT) LED indicators for issues.
Troubleshooting thermal, voltage, or short circuit protection.
Addressing no or low audio output problems.
Resolving alternator whine and ground loop noise.
Steps for returning defective merchandise for service.
Exclusions from warranty coverage.
Expected time for warranty repairs.
Summary of harmonic distortion, S/N ratio, and protection circuit tests.
To Next Page
