Need help?Do you have a question about the Kicker KEY500.1 and is the answer not in the manual?
General| Amplifier Class | D |
|---|---|
| Number of Channels | 1 |
| Frequency Response | 20 Hz - 200 Hz |
| Signal to Noise Ratio | > 90 dB |
| Input Sensitivity | 200 mV - 4 V |
| Crossover | Variable Low Pass |
| Warranty | 1 Year |
| Rated Power @ 1 Ohm | 500 Watts |
| Rated Power @ 2 Ohms | 300 Watts |
| Subsonic Filter | 20 Hz |
| Low Pass Crossover | 50Hz - 200Hz |
| Bass Boost | 0 - 12 dB |
Critical safety warnings for amplifier operation and installation, including fire and hearing hazards.
Detailed steps and considerations for securely mounting the amplifier unit.
General description of the KEY500.1's capabilities, including DSP and automatic calibration.
How to set the input gain and utilize Gain Matching to prevent clipping and optimize signal levels.
Details on using the HI-PASS and LO-PASS filters to manage speaker frequencies and protect drivers.
Explanation of Bass Boost and Remote Bass controls for adjusting low-frequency output.
Specific steps to set the amplifier's gain using the Gain Match track and LED indicator.
Instructions for running the KEY algorithm to automatically tune the audio system and apply corrections.
Steps to follow for returning a product for warranty service or repair.
Details on conditions and damages not covered by the KICKER product warranty.
Information on the expected turnaround time for warranty repairs and service.
To Next Page
