4
Remote Bass Level Control
When using AMP 2 as a subwoofer amplifier you have the ability to control the
level of the subs from the driver’s seat. To mount the controller simply screw the
metal bracket to the chosen location, then slide the housing onto the bracket
until it snaps into place. Run the cable from the controller to the appropriate
jack on the amplifier chassis.
System Diagrams
The following diagrams show the most common configurations for your sys-
tem.
Stereo Four Channel Operation
KX amplifiers are capable of operating into a minimum impedence of 2 ohms
per channel in stereo operation.
To Next Page
