19
Use only the following 9 volt batteries for smoke alarm replacement:
Carbon Zinc Type: GOLD PEAK 1604P or 1604S
Alkaline Type: ENERGIZER 522, GOLD PEAK 1604A;
DURACELL MN1604, MX1604;
NOTE: Do not use lithium batteries in this unit.
11.Battery
WARNING: Alarm will not attach to mounting bracket unless battery is installed.
Removal of battery will render the unit inoperative.
To replace the battery, remove the alarm from the mounting bracket by rotating the alarm in the direction of the
“OFF” arrow on the cover.
The Smoke Alarm is powered by a 9V battery. A fresh battery should last for one year under normal operating
conditions.
Low Battery
This alarm has a low battery monitor circuit which will cause the alarm to “chirp” and ash the red LED for a
minimum of 30 days when the battery gets low (see Troubleshooting Guide). Replace the battery when this
condition occurs, and test the unit after battery is replaced.
NOTE: Weekly testing is required.
WARNING! Use only the batteries specied. Use of different batteries may have a detrimental
effect on the smoke alarm.
NOTE: Constant exposures to extreme temperatures or humidity may reduce battery life.
To Next Page
Loading...
Need help?
General
