Need help?Do you have a question about the Kidde AirSense Stratos Micra 25 and is the answer not in the manual?
General| Power Source | 24V DC |
|---|---|
| Compliance | EN54-20 |
| Sampling Method | Continuous air sampling |
| Interconnectability | Yes |
| Alarm Sound | 85 dB audible alarm with voice alert |
| Hush Feature | Yes |
| Low Battery Signal | Yes |
| Operating Humidity | 10% to 95% RH, non-condensing |
Details the meaning of Fire, Fault, and OK indicator lights on the detector panel.
Illustrates and identifies internal components like terminal blocks, filter, and ports.
Explains the wiring and functional connections of the detector's terminal blocks.
Sets the internal calendar/clock for event logging and time-based functions.
Configures sensitivity thresholds and time delays for various alarm states.
Sets detector sensitivity to match the environment, affecting nuisance alarms.
Manages the detector's initial learning period for environmental acclimatization.
Manages special testing modes and automatic sensitivity switching.
Enables remote resetting of alarms/faults and programmed isolation for maintenance.
Configures use of a reference detector for improved accuracy and sensitivity.
Configures the delay before a flow fault is generated to prevent nuisance faults.
Sets security access codes and controls the rate of internal chart log recording.
Manages dust separator monitoring, replacement scheduling, and factory resets.
Explains how to reset latching alarms or faults using the remote software.
Visualizes detector status, sensitivity, and historical data trends.
Enables saving custom detector settings to disk and loading them back.
Guidance on sampling pipe layout and placement for optimal detection.
Details installation requirements and sensitivity for EN54-20 and UL standards.
Covers the mounting and connection of docking stations for detectors.
Details power supply, signal, and relay connections for detector installation.
Describes the final steps of physically installing the detector onto its docking station.
Explains how to assign unique addresses to detectors for network identification.
Details wiring for connecting detectors to a SenseNET or RS485 network.
Describes connecting the detector to an addressable fire panel using an APIC card.
Explains how to connect a detector to a PC for setup and monitoring via RS232.
Details the types of events recorded and how to access the detector's event log.
Covers using the remote software to perform diagnostic checks on detector functions.
Provides a step-by-step guide for initial detector setup and verification.
Outlines basic cleaning and dust separator replacement for ongoing operation.
Addresses common causes and solutions for frequent nuisance alarms.
Troubleshooting steps when smoke detection fails to trigger an alarm.
Diagnosing and rectifying issues related to airflow faults or limits.
Key recommendations and warnings for correct detector installation and operation.
To Next Page
