5
1. Alarm and Operation Audible and Visual Indicators
2. Troubleshooting Guide
3. Introduction, Product Features and Specifications
Introduction
This device detects water leaks using two electrodes on the bottom of the device. It also
monitors for rapid temperature changes to notify you of potential freezing dangers.
ISED Compliance Notice
This device complies with Industry Canada’s license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
If you are experiencing a problem with your detector, or a fault, and are unsure of the next action, please
contact product support at 1-877-542-5471. You may also write us at: Kidde Canada Inc., P.O. Box 40,
Apsley, ON K0L 1A0. Our internet address is www.kiddecanada.com.
Problem Reasons Solutions:
Unit alarming while
detecting water, but the
status in the app does
not change.
1. Detector has not been registered with the app.
2. Mobile device doesn’t connect to the Wi-Fi
network.
3. Distance between detector and Wi-Fi router is
too large.
1. Refer to sections 5 and 6.
2. Connect the Wi-Fi and reconfigure the network.
3. Adjust the installation location.
Detector will not alarm
while there is water
leaking.
1. The detector is not sitting horizontally.
2. The batteries are depleted.
1. Adjust the installation position.
2. Replace batteries.
Power Two AA batteries
Environment 0 - 40 °C (32 - 104°F),
≤
90% RH non-condensing
Waterproof level
IP65
Audible alarm
85+
dB at 3ft (1m)
Water depth detection capability
> 0.015” in depth
Wi-Fi Requires 802.11b/g/n (2.4GHz) Wi-Fi.
To Next Page