8
5. Introduction, Product Features And Specifications
Introduction
This alarm detects products of combustion using a photoelectric sensor and carbon monoxide using an electro-
chemical cell. Many times throughout this User Guide, we will refer to Carbon Monoxide as “CO.”
Ten (10) years after the unit was installed, this unit will automatically alert you that it is time to replace the unit.
This is called “End of Unit Life” mode. See Troubleshooting Guide. To help identify the date to replace the unit, a
label has been affixed to the side of the alarm. Write the “Install date” in the space provided, and then write in
the “Replace by” date (10 years from initial power up) in permanent marker on the label prior to installing the unit.
Product Features and Specifications:
• Temperature Operating Range: 4.4°C (40°F) to 37.8°C (100°F)
• Humidity Operating range: 10-95% RH non-condensing
• Audible Alarm: 85+ dB at 3m (10ft), 3.0 to 3.5 KHz pulsing alarm, with voice messages “Fire! Feu!,” and/or
“Warning! Carbon monoxide, Monoxyde de carbone!”
• Smoke Sensor: Photoelectric
• CO Sensor: Electrochemical
• Smoke Alarm Hush
TM
• Powered by 120VAC (60 Hz, 42 mA max) wire-in connector with two AA battery backup.
• Hardwire interconnectable to other compatible alarms.
• Self-testing (see section 10)
• Voice message system
• This Class B digital apparatus complies with Canadian ICES-003.
ISED Compliance Notice
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
To Next Page
Loading...
