20
NOTE: Wireless units will emit a series of LED blinks, tones, and voices as the unit(s) search for a wireless alarm
network. If you are intending to use wireless units without the wireless function, ignore these notifications, and
the wireless function will turn off in about 15 minutes. You can turn the wireless function on again at a later date if
desired. See Section 9.2.
NOTE: Attaching AC power first, without rotating the alarm onto the mounting bracket, will result in a low battery
trouble condition chirp (see Troubleshooting Guide). You need to activate the battery to eliminate the low battery
trouble condition chirps. Attach unit to mounting bracket very soon after applying AC power to avoid false low
battery notification.
NOTE: The battery activation is a one-time feature. After activation, the battery cannot be turned off, and can
only be discharged at the end of unit life. If the alarm is removed from the mounting plate, the backup battery will
remain active. See Permanently Disable Alarm / Discharge Battery section.
The alarm is now activated! After installation / activation, test your alarm as described in Operation and Testing section.
WARNING: FAILURE TO PROPERLY INSTALL AND ACTIVATE THIS ALARM WILL PREVENT PROPER
OPERATION OF THIS ALARM AND WILL PREVENT ITS RESPONSE TO FIRE HAZARDS.
Interconnect Capability
These models have AC hardwire AND wireless alarm interconnect capability. When one hardwire or wireless intercon-
nect unit sounds an alarm, all other compatible hardwire or wireless interconnected units will also alarm.
To Next Page
Loading...
Need help?
General
