Kidde VM-1 Technical Reference Manual

Chapter 3: Operating instructions
40 P/N 3101890-EN • REV 006 • ISS 21JUN18
Viewing reports
System reports are used to check the current condition or history of the VM-1 life safety network. A report can be
displayed on the LCD screen or printed to a local printer.
Status reports
The status reports listed below are available to help you determine the current state of the system.
• All Active Points: Lists all addressable points that are in an active (alarm) state
• Alarm: Lists all active alarm input device types
• Supervisory: Lists all active supervisory input device types
• Trouble: Lists all points in trouble
• Monitor: Lists all active monitor input device types
• Test: Lists points in an active service group that are in the active or trouble state
• Disabled Points: Lists all addressable points that are disabled
• Outputs: Lists all active output device types and control-indicating module LEDs
To access a status report:
1. Access the Main Menu, and then select Status.
2. Select the desired report.
3. Enter the panel address.
4. Select Display and scroll through the report.
— or —
Select Print Locally.
5. When finished, exit the screen.
Abnormal points report
Use the All Active Points command on the Status Menu to display or print a list that includes all points in the
system that are not in their normal state.
Note: During normal operation, most points in the system are not active. Points whose normal state is active are
included in the list.
To display or print a list of all abnormal points:
1. Access the Main Menu, and then select Status.
2. Select All Active Points.
3. Enter the panel address.
4. Select Display and scroll through the report.
— or —
Select Print Locally.
5. When finished, exit the screen.

Kidde VM-1 Specifications

General

Brand	Kidde
Model	VM-1
Category	Fire Alarms
Language	English