8 KiloLink Server
8.1 4G network connection
Login to the device Web page, click “Network & Service Settings” – "Network interface
management", and click "Settings"-"Add a new wireless WAN connection" of the 4G card.
Introduction
⚫ If the platform RTMP streaming address and live broadcast code are separate, please use the symbol
"/" to add the live broadcast code after the RTMP address. The format is: rtmp address/live code.
⚫ Please make sure the device is connected to the network, and configure the correct IP address, DNS
and other parameters.
For more information about the P1 streaming service, please visit
Kiloview website:
https://www.kiloview.com/en/support/docs/p2/user/parameters-
configuration/encoding-streaming-media/#Streaming_media_service
Introduction
⚫ The device can support up to 5 networks transmission:
1. 2 internal 4G modems + 2 USB extensions 4G modems + one WIFI
2. 2 internal 4G modems + 1 USB extensions 4G modems + one WIFI + one Ethernet.
⚫ When inserting 4G USB modems, there are two modes: one is “MODEM” mode, the other is
“ETHERNET CARD” mode. In the MODEM mode, it will be recognized as 3G/4G Modem 3 or 3G/4G
Modem 4. In the ETHERNET CARD mode, it will be recognized as USB network connection 1 or USB
network connection 2.
⚫ The device does not support hot swapping of the SIM card, please insert the 4G SIM card when the
device is off, or restart the device after inserting the SIM card
To Next Page
Loading...
Need help?
General
