Why is my Kinetico Water Filtration System losing water pressure?
Loss of water pressure in your Kinetico Water Filtration System can occur due to: * Scaling or fouling of the inlet pipe: Clean or replace the pipeline and consider pretreatment to prevent future issues. * Fouled media: Clean the media and pretreat to prevent recurrence. * Improper backwash setting: Increase the frequency of backwashing.
What to do if my Kinetico Water Filtration System regenerates at the wrong time?
If your Kinetico Water Filtration System regenerates at the wrong time, it could be due to: * Time of day improperly set, often caused by a power failure: Reset the time of day programming and consider installing a 9-volt battery. * Regeneration time set improperly: Reset the regeneration time programming.
What to do if my Kinetico Water Filtration System has poor water quality?
If you're experiencing poor water quality with your Kinetico Water Filtration System, consider the following: * Iron or Sulfur Bacteria presence: Add further treatment to address these issues. * By-pass valve open: Ensure the by-pass valve is closed. * Channeling: Check for service flow that is too slow or too high, and inspect for media fouling. * Lack of aeration in water: Program the valve to draw air more frequently and increase the duration of the air draw cycle. Clean the injection assembly and screen.
Why my Kinetico Water Filtration System fails to regenerate automatically?
Your Kinetico Water Filtration System might fail to regenerate automatically due to: * The power supply being plugged into an intermittent or dead power source: Connect to a constant power source. * Improper control valve programming: Reset the program settings. * A defective power supply: Replace the power supply.
Setting time, days between backwash, and air draw cycles via the control panel.
Probable causes and corrections for automatic regeneration failures.
Causes and corrections for regeneration occurring at incorrect times.
Troubleshooting steps for issues related to poor water quality output.
Causes and corrections for reduced water pressure.
Diagnosis and fixes for water continuously flowing to the drain.
Issues and solutions for media appearing in the service line.
General| Model | Powerline PRO 1354FA |
|---|---|
| Type | Water Softener |
| Tank Material | Fiberglass |
| Operating Pressure | 20-125 psi |
| Resin Type | High-Capacity Cation Resin |
| Brine Tank Capacity | 250 lbs salt |
To Next Page