Need help?Do you have a question about the Kinetico K5 and is the answer not in the manual?
General| Filter Type | Reverse Osmosis |
|---|---|
| Daily Production Rate | 50 gallons per day |
| Certifications | NSF/ANSI 58 |
| Filter Life | 6-12 months |
| Waste Water Ratio | 1:1 |
Checks if the membrane produces water at the faucet, guiding initial troubleshooting steps.
Verifies the Puremometer's position, crucial for diagnosing system operation.
Details the Jack Screw Priming Method for system setup and troubleshooting.
Tests if the turbine moves when the faucet is closed to diagnose flow issues.
Diagnoses system pulsing when the faucet is open, identifying potential causes.
Checks turbine movement when the faucet is closed to troubleshoot pulsing.
Addresses issues related to exceeding recommended faucet tube lengths.
Checks if the faucet connection size is compatible, affecting system performance.
Determines if the system is connected to an icemaker for troubleshooting.
Verifies the installation of the specific ice maker kit for proper function.
Measures TDS rejection rate to diagnose high TDS issues in the system.
Temporarily bypasses auxiliary and post filters to diagnose TDS problems.
Checks jack screw position and drain flow to identify TDS-related issues.
Procedure for replacing the membrane to resolve high TDS problems.
Replaces FC#1 and the membrane to address specific TDS issues.
Checks if the system is providing water at the faucet during operation.
Verifies if the system shuts down correctly as expected.
Checks turbine movement when faucet is closed in a run-to-drain scenario.
Addresses issues with the bladder connection or requires bladder replacement.
Replaces CV6 valve to resolve run-to-drain problems.
Replaces CV3 valve to resolve run-to-drain problems.
Diagnoses pulsing when dispensing appliances are in use.
Checks if the feed line to appliances meets size requirements.
Guidance on upsizing feed tubing to resolve pulsing issues with appliances.
Verifies if the icemaker kit is installed for appliance-related pulsing.
Details installing an accumulator tank and check valve for appliance use.
Instructs on installing a flow suppressor to mitigate pulsing issues.
To Next Page
