Need help?Do you have a question about the Kinetico Powerline PRO and is the answer not in the manual?
General| Brand | Kinetico |
|---|---|
| Model | Powerline PRO |
| Category | Water Dispenser |
| Language | English |
System control regenerates softener on a given day of week using a 12-day timer.
Regenerates based on actual water used, tracked by an integrated system meter.
Reverses water flow through mineral tank to flush particles to drain.
Uses brine to remove hardness ions and rinses excess brine.
Settles and recompacts resin bed by directing water flow downward.
Adds fresh water to salt compartment for new brine solution.
Normal operation cycle where hard water exchanges ions for soft water.
Ensure salt level in brine tank is above water line; do not use rock salt.
Inlet water pressure range of 20-125 psi is required for effective operation.
Requires uninterrupted AC supply; voltage must be compatible; 9-Volt battery backup recommended.
Plumbing should be free from buildup; replace piping or install iron filter if needed.
Install if unit is not equipped; turn to bypass position if leaking.
Guide for setting time of day, AM/PM, and compensated hardness.
Instructions for using Bluetooth interface with compatible smart devices.
Maintains time of day during power failures; display turns off to conserve power.
Initiate delayed or immediate extra regeneration cycles manually.
Details common cycle step times: Backwash, Brine Draw, Rapid Rinse, Brine Refill.
Addresses issues with power supply, meter, or control valve programming.
Troubleshoots issues related to time of day, regeneration time, and hardness settings.
Covers causes like resin fouling, internal valve leaks, and resin age.
Investigates issues like by-pass valve, channeling, high salt setting, or brine tank water.
Addresses constant flow or regenerating too frequently.
Troubleshoots scaling, fouling of inlet pipe, or improper backwash settings.
Diagnoses problems with drain line, brine valve, injector screen, or low inlet pressure.
Covers issues like no water in brine tank or low water pressure.
Addresses problems with jammed valves or motors.
Lists error messages indicating potential control valve issues and required service.
To Next Page