Page 21
SET SERVICE PROVIDER CODE
1. Press * 24 # to display the current service provider code
(see chart on page 19).
2. To change the current service provider, press * 96 #
* 66 #
* 88 #
3. Press the UP and DOWN arrows (2 and 8 keys) to choose your desired service provider from
the chart on page 19.
4. Press * 25 # to lock in setting.
5. Turn unit OFF and back ON to save setting.
6. Press * 24 # to display and verify setting for new service provider.
7. Press OFF.
8. Unplug the Keypad and plug the controller back in.
9. Continue with RECEIVER CONFIGURATION below.
RECEIVER CONFIGURATION
DIRECTV SD with Locals
If you have a newer receiver or current software, choose the following dish confi guration
settings (do this through the receiver’s satellite set-up menu screens):
Switch Type: 02:Multiswitch Dish Type: 02: 3-LNB (18 x 20”)
If you have an older receiver, choose oval dish-2 satellites.
Confi guration is complete. Go to page 26.
For all of the following, go to page 23 and run the check switch test.
DISH SD
DISH SD and HD
DISH SD and HD Alternate
Bell TV SD
Bell TV SD and HD
To Next Page
Loading...
