King gates STARG8 24NG User Manual

STARG8 24NG
Made in Italy
IT Centrale di comando per motori 24V di cancelli scorrevoli e battenti
Istruzioni ed avvertenze per l’installazione e l’uso
EN Control unit for 24V sliding and swing gates motors
Installation and use instructions
FR Centrale de commande pour moteurs de portails coulissants et
battants à 24V. Consignes pour l’installation et l’utilisation
ES Central de mando para motores de puertas batientes y correderas
de 24V. Instrucciones y advertencias para la instalación y el uso
PT Central de comando para motores 24 V para portão de correr ou de
batente. Instruções de instalação e utilização
DE Steuerung für 24-V-Motoren für Schiebe- und Drehügeltore
Installations- und Bedienungsanleitung
1 2 3 4 5 6 7 8
PH 01
PH 02
GND
+ VA
GS I
OL 1
CL 1
OL 2
CL 2
STR
GND
GND
STP
PED
ANT
GND
AUXHAZ
MOT 1MOT 2
VH
VRE F
VL

King gates STARG8 24NG Specifications

General

Power Supply	24V DC
Maximum Gate Weight	800 kg
Protection Rating	IP44
Control Options	Remote control
Safety Features	Obstacle detection
Maximum Gate Width	8 meters
Motor Type	24V DC Motor

Summary

General Warnings

Safety Warnings

Important instructions and warnings for personal safety during installation and operation.

Installation Warnings

Crucial precautions for safe and correct installation of the automation system.

Wiring

Control Unit Setting

Dip-Switch Adjustment

Configuration of DIP switches to set motor type, operating modes, and functions.

Knob Adjustment

Adjustment of motor power, obstacle sensitivity, pause time, and delay via control knobs.

Transmitter Programming

Start Button Programming

Programming the Gate Travel

Basic Programming of Gate Travel

Essential procedure for learning gate open/close points and slowdown for basic operation.

Programming Pedestrian Opening Width

Advanced Programming of Gate Travel

Fine-tuning slowdown points and gate travel parameters beyond basic settings.

Operation and Status Checks

Testing and Commissioning

Final checks to verify correct operation after programming and installation.

LEDs Indication

Reset Procedure

Restoring the control unit to factory settings, deleting gate travel parameters.

Devices Connectable to the Control Unit

Motors

Photocells and Safety Edges

Wiring and configuration for safety devices like photocells and safety edges.

Wired Commands

Back-Up Battery / Energy Saving

AUX Output Programming

AUX Output Configuration

Configuring AUX output modes, voltage, and assigning transmitter buttons.

Photocells and Safety Edges Advanced Programming

Photo-Test Configuration

Activating/deactivating photo-test and selecting linked outputs/device types for safety.