KING EXTEND PRO KX2000 - Technical Specifications; FCC Compliance Statement

Page 11
Each signal booster is individually tested and factory set to ensure FCC
compliance. The signal booster cannot be adjusted without factory
reprogramming or disabling the hardware. The signal booster will amplify, but not
alter incoming and outgoing signals in order to increase coverage of authorized
frequencybandsonly.Ifthesignalboosterisnotinuseforveminutes,it
will reduce gain until a signal is detected. If a detected signal is too high in a
frequency band, or if the signal booster detects an oscillation, the signal booster
willautomaticallyturnthepowero󰀨onthatband.Foradetectedoscillation
the signal booster will automatically resume normal operation after a minimum
ofoneminute.Aftervesuchautomaticrestarts,anyproblematicbandsare
permanentlyshuto󰀨untilthesignalboosterhasbeenmanuallyrestartedby
momentarily removing power from the signal booster. Noise power, gain, and
linearity are maintained by the signal booster’s microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
causeundesiredoperation.Changesormodicationsnotexpresslyapprovedby
weBoost could void the authority to operate this equipment.
FCC
Model
Connectors
Antenna Impedance
Frequency
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Isolation
Power Requirements
Noise Figure
>90 dB
12 V, 1.8 A
KC1331
5 dB (nominal)
PWO460061
470061
SMB-Jack
50 Ohms
698-716 MHz, 728-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700 MHz
Band 12/17
25.4
700 MHz
Band 13
25.6
1700 MHz
Band 4
26.7
800 MHz
Band 5
25.6
1900 MHz
Band 25/2
26.9
4.8 4.8 4.64.8 4.5
SPECIFICATIONS