Page 9
TROUBLESHOOTING
Need help? KING Customer Service: (952) 345-8147
FIXING BLINKING OR SOLID RED ISSUES
This section is only applicable if the signal booster light is red or blinking
red and you are not experiencing the desired signal boost.
1. Unplug the signal booster’s power supply.
2. Relocate the inside and outside antennas further away from each other.
The objective is to increase the separation between them, so that they will
not create the feedback condition discussed on page 3.
3. Plug power supply back in.
4. Monitor the indicator light on your signal booster. If after a few seconds of
“power on”, a solid blinking red light appears, repeat steps 1 through 3.
Increase the separation distance until the condition is corrected and/or
desired coverage area is achieved.
TIP
Increasing vertical separation between antennas
typically improves isolation better than increasing
horizontal separation.
To Next Page
Loading...